Therefore if you have the primary uplink configured as WAN 1 then you must use WAN 1's Public IP address. Please note that this must be the IP address of the primary interface specified on the MX under Security & SD-WAN > Monitor > Appliance status > Uplink > Configuration > General. On the second screen, you need to enter the public IP address of the MX security appliance in the text box labeled Peer IP address. Select Site-to-Site and leave the VPN tunnel interface as outside then click the 'Next' button. On the first screen, you will be prompted to select the type of VPN. The easiest way to configure the VPN tunnel is by logging onto your Cisco ASA via the ASDM GUI and utilizing the IPsec Wizard found under Wizards > IPsec VPN Wizard. Note: The following screenshots should be used as a guide as your wizard may vary depending on the version of ASDM which is being used.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |